User manual

[] Initial Setup

Thissectionwill guideyouthroughtheunit'sinitialsettingwhichincludes

selectingalanguageforyouron-screenmenuandautochannelscan,

whichautomaticallyscansandmemorizesviewablechannels,

Before you begin:

Makesureifthe unitisconnectedto antenna orcable.

After making all the necessary connections, press

[POWER] to turn on the unit.

POWER

• This operation maytake a few moments.

2 Use [Cursor l/Y] to select the on-screen language

from the choices on the right side of the TV screen.

(English / Espa6ol / Fran_ais)

• "Initial Setup" menu on step 3 will be displayed in the

selected language after you press [ENTER].

Use [Cursor l/V] to select "Air" for TV channels or

"Cable" for CATV channels, then press [ENTER].

• Scanning and memorizing of channels start

automatically.

Note:

• Ifyou connect the cable system directly, contact the CATV

installer.

• Ifyou press[POWER] or [SETUP] during auto channel

scan, this setting will be canceled.

• Theinitial auto channel scan function can be executed

for either "Air" or "Cable"only once. Whenyou change the

connection (Air/Cable), set auto channel scan again. (Refer

to page 14.)

• Youcan cancel or exit the initial auto channel scan menu

bypressing [SETUP].

• If there is no signal input from the antenna terminal and

no operation for several secondsafter you turn on the unit,

"Helpful Hints" appears. Follow the instructions listed on

the TVscreen.

!,,7_

ii !!i,i_]i

i 7 ¸

ii 111!7

iJtJ

! i71::

• When the scanning and memorizing are completed,

the lowest memorized channel in the broadcasting

will be displayed.