User manual

[] Basic Connection

Thissectiondescribeshowto connectthe unit toanantenna,cable/satellitebox,etc.

I Note:

• Besureyourantennaorotherdeviceisconnectedproperlybeforeplugginginthepowercord.

[Antenna Cable Connection]

When connectinq the unit to an antenna or cable TV company (without cable/satellite box)

Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.

e.g.)

VHF/UHF'_

antenna _ '

rear of this unit

RF coaxial cable

cableTV

company

Once connections are completed, turn on the unit and begin initial setup.

Channel scanning is necessary for the unit to memorize all available channels in your area.

(Refer to "Initial Setup" on page 13.)

Note:

• Foryour safety and to avoid damage to device,please unplug the RFcoaxial cable from the antenna inputjock before moving the unit.

• lfyou usean an tenna to receiveanalog TV,it should also work for DTVreception. Outdoor or attic an tennas will be more effective than

settop versions.

• Toeasilyswitch your reception source between antenna and cable, install an antenna selector.

• Ifyou connect to the cable system directly, contact the CATVinstaller.

[Connection to Cable Box or Satellite Box]

Connect the RFcoaxial cable on your home outlet to the input jack of the cable/satellite box.

Use another RF coaxial cable to connect the antenna input jack of the unit to the output jack of the cable/satellite box,

e.g.)

satellite

dish

cable/satellite box

rear of this unit

cable TV RF coaxial cable RF coaxial cable

company

* Required cables and connecting methods differ depending on the cable/satellite box.

For more information, please contact your cable/satellite provider.