Operation Manual

Oil Filter Cleaning
Open the filter nut assembly of the element, and
remove the element. Remove the foreign materials
from the element by using a gasoline or air spraying
gun.
WARNING:
Oil level will not be correct when checking the oil level with the scooter parked on an unleveled
ground or immediately after the engine stopped.
Engine and exhaust pipe are hot right after engine stopped. Pay special attention not to get burned
when checking or replacing engine oil.
FUEL INSPECTION
Turn main switch key to "ON" position, and check fuel gauge's needle range to make sure there is enough
amount of fuel in the fuel tank.
This scooter’s engine is designed for using the unleaded fuel of Octane 90 or above.
Firmly secure the main stand on the ground, shut off the engine and keep flames away from the scooter
when refueling.
Do not fill above fuel upper limit level when refueling.
Make sure the fuel tank cap had been tighten properly.
Ethanol in gasoline can not be more than 10%.
TRANSMISSION OIL INSPECTION AND CHANGE
INSPECTION:
Use the main stand to support the scooter on a level ground, after the engine stops, wait for 3~5 minutes.
Remove the transmission oil infusion bolt, put a measuring glass under the drain bolt, and remove the
drain bolt. Let the oil flows into measuring glass and check for decreased or not. (at disassembly: 110
cc. / at change: 90~100 cc.).
OIL REPLACEMENT:
Stop the engine and use the main stand to support your scooter on a level ground. Remove the infusion
bolt and drain bolt, drain out the oil.
Install the drain bolt and tighten it. Fill new transmission oil (90~100 cc.), and install the infusion bolt and
tighten it. (make sure that bolts are tightened and check that there’s no leakage.)
Recommend Oil: Genuine SYM HYPOID GEAR OIL (SAE 85W-140).
Use SAE85-90 when outside temperature is below 0.
INSPECTION AND ADJUSTMENT OF BRAKE FREE PLAY
INSPECTION: (Brake lever free play must be checked with the engine shut off.)
Brake lever free play for front and rear wheels
When checking the hand-braking lever for front and rear wheels, its free play (the stroke of hand-braking
lever from no braking to initial braking) should be 10~20mm. It is abnormal if the feel is spongy when
holding the hand-braking lever forcefully.
10~20 mm
10.Inspection and Maintenance before Riding
15