Operation Manual

8. V-Belt Drive System / Kick Starter

8-12

Clutch Block Replacement

Remove snap and washer, and the remove clutch

block and spring from driving plate.

Check if spring is damage or insufficient elasticity.

Check if shock absorption rubber is damage or

deformation. Replace it if necessary.

Apply with grease onto setting pins.

Apply with grease onto setting pins. But, the

clutch block should not be greased. If so, replace

it.

Install new clutch block onto setting pin and then

push to specified location.

Caution

z Grease or lubricant will damage the clutch

block and affect the block’s connection

capacity.

Install the spring snap into groove with pliers.

Clutch block

Shock absorption rubber

Snap ring

Spring

Drive plate

Clutch block

Setting pin

Shock absorption

rubber

To this chapter contents