Operation Manual

8. V-Belt Drive System / Kick Starter

8-14

Installation of Clutch / Driven Pulley

Assembly

Install new oil seal and O-ring onto sliding driven

face. Apply with specified grease to lubricate the

inside of sliding driven face.

Install sliding driven face onto driven face.

Install guide pin and guide pin roller.

Install oil seal collar.

Install driven pulley spring and clutch into clutch

spring compressor, and press down the assembly

by turning manual lever until mounting nut that can

be installed.

Hold the compressor by bench vise and tighten

the mounting nut to specified torque with special

nut wrench.

Remove the clutch spring compressor.

Torque value: 5.0~6.0kg-m

Install clutch/driven pulley and driving belt onto

driving shaft.

Oil seal

O-ring

Specified

grease

Guide pin roller

Guide pin

Oil seal

Sliding driven face

O-ring

Special nut wrench

Clutch spring compressor

Oil seal collar

To this cha

ter contents