Operation Manual

25
§CHECKING THE TURN SIGNAL LIGHTS AND HORN §
 Turn the ignition switch key to the “ON” position.
 Turn on the turn signal light switch, and
make sure that the front & rear and left &
right signal lights flashes and also check if
the warning buzzer sounds.
 Check turn signal light covers if they are dirty,
crack, or loosen.
 Press horn button to check if it works.
§CHECKING THE FRONT AND REAR LIGHTS §
 Start engine and turn on the head lamp
switch. Check if head lamp and rear lamp
come on.
 Check the brightness and direction of front
light by wall to see if it is correct.
 Check the head lamp cover if it is dirty,
crack, or loosen.
§CHECKING THE BRAKE LIGHT §
 Turn the ignition switch key to the “ON”
position, hold the hand-braking levers for
front and rear wheels. Check if the brake
lights come on.
 Check the brake light cover if it is dirty, crack,
or loosen.
CAUTION:
 Specified specification bulbs should be used for
turn signal lights. Otherwise, the normal
operation of turn signal lights will be affected.
 Turn on the turn signal light before turning or
switching lane to warn driver of vehicles
behind.
 Turn off the turn signal light immediately by
pressing its button down after using.
Otherwise, the flashing of twin signal lights may
confuse the drivers of vehicles behind.
CAUTION:
 Use only specified specification bulbs, do not use bulbs with different specifications to avoid
damaging electrical system, burning out bulbs, and discharging the battery.
 Do not modify or add other electrical components to prevent over load or short circuit which
may result in a fire and burn down the motorcycle in serious cases.