Operation Manual

8
When the switch is turned to this position as the engine is being started, rear light,
instrument panel light, and position light will come on. This is the low beam of headlight
switching switch. (Please turn to low beam when riding in city)
When the switch is turned to this position, all lights will go off.
 Hazard Switch
Turn ignition switch to the “ON” position and turn this button to right. Then, the front (left/right)
winker and the rear (left/right) winker will come on immediately to warn the driver of the vehicle
ahead that you intend to overtake him/her. (For overtaking, trun left/right signal indicator will
come on at this time) This button will return to original position after releasing.
 Electrical Starter Button
This is a starting motor button (switch) for engine starting.
 High/Low Beam Switch
This is the high and low beam of headlight switching switch. Press this switch to switch between
high and low beams.
This is for high beam.
This is for low beam. (Please turn to low beam when riding in city)
 Horn Switch
Press this button down when ignition switch is in the “ON” position, the horn will sound.
 Turn Signal Switch
Turn signal lights are used when turning left/right or changing lane.
Turn ignition switch to the “ON” position, and slide the turn signal switch to left or right. Then, the
turn signal lights will flash.
To release, simply return the turn signal light button to the original position.
Right-side turn signal light flashing means you intend to make a right turn.
Left-side turn signal light flashing means you intend to make a left turn.
CAUTION:
 Release this button immediately after engine has been started, and never press the button
again to avoid damaging the engine.
 Do not use light system. Turn headlight and turn signal lights to the “●” position when the
engine is being started.
CAUTION:
Do not press this button when you are in the area where there’s no honking.