14.0

3
Select which recovery point to copy, and then click OK.
4
On the Welcome page of the Copy Recovery Point Wizard, click Next.
5
Select the recovery point that you want to copy.
Recovery point sets appear as single recovery points. Check View allrecovery
points to display all incremental recovery points that are included within
the recovery point sets.
6
Click Next.
7
Do one of the following:
■ In the Folder box, type the path to which you want to copy the recovery
point.
■ Click Browse to locate the folder to which you want to copy the recovery
point, and then click OK.
8
Select a level of compression for the copies of the recovery points.
See “About setting a compression level for drive-based backups” on page 72.
9
If you want to verify whether a recovery point is valid once the copy is
complete, check Verify recovery point after creation.
10
Click Advanced, and then select from the following options:
■ Divide into smaller files to simplify archiving
■ Use password
See “Setting advanced options for drive-based backups” on page 68.
11
Click OK.
12
Click Next, review the options that you selected, and then click Finish.
Once the recovery points are safely copied, you can delete them from your
computer.
See “Deleting a recovery point set” on page 128.
Converting a recovery point to a virtual disk format
You can use Norton Ghost to convert recovery points of a physical computer to a
VMWare Virtual Disk (.vmdk) or a Microsoft Virtual Disk (.vhd).
Virtual disks created from recovery points are supported by the following
platforms:
■ VMware GSX Server 3.1 and 3.2
■ VMware Server 1.0
Managing backup destinations
Converting a recovery point to a virtual disk format
130