User's Guide
Table Of Contents
- MC3000 User Guide
- Revision History
- Contents
- About This Guide
- Getting Started
- Introduction
- Unpacking the Mobile Computer
- Accessories
- Parts
- Mobile Computer Startup
- Battery Charging
- Spare Battery Charging
- Stylus
- Starting the Mobile Computer
- Waking the Mobile Computer
- Main Battery Removal
- Strap/Door Assembly Removal and Replacement (MC3000-K/R)
- Strap/Door Assembly Removal and Replacement (MC3000-G)
- Operating the MC3000
- Using Bluetooth
- Accessories
- Maintenance & Troubleshooting
- Technical Specifications
- Keypad Functions/Special Characters
- Regulatory
- Glossary
- Index
- Tell Us What You Think...
MC3000 Integrator Guide1-16
Strap/Door Assembly Removal and Replacement (MC3000-G)
The Strap/Door Assembly consists of a hand strap and the battery door. Before removing the Strap/Door Assembly, press the red
Power button to turn off the screen and set the mobile computer to suspend mode.
To remove the Strap/Door Assembly:
1. Rotate the latches to the open position.
Do not lift up on the latches when removing the Strap/Door Assembly. Lift up on the Hand Strap only.
2. Lift the Hand Strap to lift the Strap/Door Assembly off, bottom first.
3. NEED STEPS
Reverse the procedure to replace the Strap/Door Assembly.
Figure 1-13. Strap/Door Removal and Replacement (MC3000-G)
Strap/Door
Assembly
Latches
Screws
#00 Phillips
Screwdriver
Mounting
Clip
Strap Loop
Mounting
Clip
Hand Strap