Mobius Model CCRF-5020-10-WW IEEE 802.
Copyright Copyright © 2002 by Symbol Technologies, Inc. All rights reserved. No part of this publication may be modified or adapted in any way, for any purposes without permission in writing from Symbol Technologies, Inc. (Symbol). The material in this manual is subject to change without notice. Symbol reserves the right to make changes to any product to improve reliability, function, or design.
Symbol Technologies, Inc. One Symbol Plaza Holtsville, N.Y. 11742-1300 Telephone: (800)SCAN234, (516) 738-2400 Telex: 6711519 http://www.symbol.
About this Document Audience This guide is intended for the technician responsible for installing the Mobius Wireless LAN Switch. It is also assumed that the technician is familiar with Ethernet LAN-based networking concepts. Purpose The purpose of this document is to provide specifications, features and guidelines for the installer to use during installation. This document does not give site-specific installation instructions.
Warnings WARNING! Only trained and qualified personnel are allowed to install this equipment. WARNING! Read all installation instructions and site survey reports, and verify correct equipment installation before connecting the system to its power source. WARNING! Remove any jewelry (rings, watches, necklaces, etc.) while installing this equipment. WARNING! Verify that any device connected to this unit is properly wired and grounded.
Introduction The Mobius Access Port provides area coverage to 802.11b wireless network devices. The Access Port includes different installing options, allowing best placement for the operate with its optimum range. The standard mounting base allows the unit to get secured to most surfaces by the use of two screws. The ceiling mounting option allows the unit to attach to ceiling by a single screw The Access Port receives power and transfers data through the same (CAT-5) cable.
Drop .
Preparing for Site Installation Verify that the contents of the box include the following: • • • Access Port Assembly Surface-Mount Assembly • Mounting Anchors • Mounting Screws • Surface-Mount Badge • Surface-Mount Cover Surface-Mount Light Pipe Screw • Ceiling-Mount Grommet • • Ceiling-Mount Badge Ceiling-Mount Light Pipe Screw • Installation Guide Review Site survey and network analysis reports to determine the method for Access Port installation.
Mobius Model 5020 Access Port Hardware Installation Guide Jun/19/2002 Page 9 of 13
Ceiling Mounting Some installations require Access Port mounting above the ceiling tile. The type of installation hides the unit and cable away from visual access. Note: Use this installation in plenum-rated ceiling configurations. Verify that the attaching Ethernet cable is also plenum rated. Caution! Use care when pulling cables attached to a mounted unit.
Power/Data (RJ-45) Connection The Access Port receives power from the Ethernet cable. It supports the following Symbol-branded Power-Over-Ethernet devices. Mobius 1-Port Power Port (Model ) Mobius 12-Port Power Port (Model ) Note: Review installation plans to determine device placement and cable routing.
Customer Support Symbol Technologies provides its customers with prompt and accurate customer support. Use the Symbol Support Center as the primary contact for any technical problem, question or support issue involving Symbol products. If the Symbol Customer Support specialists cannot solve a problem, access to all technical disciplines within Symbol becomes available for further assistance and support.
International Contacts Outside North America, contact Symbol by: • Symbol Technologies, Inc. Symbol Place Winnersh Triangle, Berkshire, RG41 5TP United Kingdom 0800-328-2424 (Inside UK) +44 118 945 7529 (Outside UK) Symbol Developer Program Web Site http://software.symbol.com/devzone Symbol Knowledge Base http://kb.symbol.com/register.
