user manual

PDT 8100 Series

with Intel XScale

Technology

Power Supply

Note:Use only a Symbol-approved power supply 50-14000-107 output rated 9Vdc

and minimum 2A. The power supply is certified to EN60950 with SELV outputs.

Hinweis:Benutzen Sie nur eine Symbol Technologies genehmigt Stromversorgung

50-14000-107 in den Ausgabe: 9Vdc und minimum 2A. Die Stromversorgung ist

bescheinigt nach EN60950 mit SELV Ausgaben.

FCC RF Exposure Guidelines

Handheld Devices:

This device was tested for typical body-worn operations with the holster providing a

minimal spacing of 2.0 cm from the body to the back of the terminal/antenna. To

maintain compliance with FCC RF exposure compliance requirements, use only belt-

clips, holsters, or similar accessories that maintain a 2.0 cm separation distance

between the user’s body and the back of the terminal, including the antenna. The use

of third-party belt-clips, holsters, and similar accessories should not contain metallic

components in its assembly. The use of these accessories that do not satisfy these

requirements may not comply with FCC RF exposure compliance requirements, and

should be avoided.

Hearing Aid Compatibility

This device is marked HAC showing compliance with the applicable requirements of

FCC Part 68 and CS03-Part 5.

Radio Frequency Interference Requirements

Note: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected

• Consult the dealer or an experienced radio/TV technician for help.

Tested to comply

with FCC Standards

FOR HOME OR OFFICE USE