User's Guide

Wireless Applications 4-17
Key Entry Page
If either 40-Bit WEP or 128-Bit WEP is selected the wizard proceeds to the key entry dialog box unless the Use Passkey check box
was selected in the Encryption Dialog Box (see Figure 4-19 on page 4-15). To enter the key information:
1. Enter the 40-bit or 128-bit keys into the fields.
2. Tap Next.
Figure 4-20. 40-Bit WEP Keys Dialog Box
Figure 4-21. 128-Bit WEP Keys Dialog Box
Passkey Dialog
When a user selects None as an authentication and WEP as an encryption, the user can chose to enter a passkey by checking the Use
PassKey check box. The user is prompted to enter the passkey. For WEP, the Use PassKey checkbox is only available if the
authentication is None.
When a user selects None as an authentication and TKIP as an encryption, the user is forced to enter a passkey. The user cannot enter
a passkey if the encryption is TKIP and the authentication is anything other than None.
Figure 4-22. Passkey Dialog Box
Tap Next. The IP Mode dialog box displays.