PDA User Manual

8-19
Spectrum24 Network Configuration
The Signal Property Page displays the following information:
A graph displays signal quality from 0 to 100 percent. The terminal continuously
looks for a stronger signal from a different access point on the network, and roams
to that access point if the quality of the radio signal drops below an acceptable level.
The bottom of the Signal page displays the current signal quality, the number of times
the terminal has roamed, the current data rate, and the network in-range status.
Using Spectrum24 Settings Control Panel Applet for PPT 2746
The Spectrum24 Settings Control Panel Applet allows you to view and edit Spectrum24 NIC
settings. During initial installation, the HR WLAN Setup screen appears. This allows you to
set the ESSID and finish the installation.
Figure 8-16. WLAN Setup Screen
Enter an ESSID (802.11 Extended Service Set Identifier) matching the access point ESSID to
enable the terminal to communicate with the access point. This value is a unique 32-character
(maximum) string that identifies the wireless local area network. If the ESSID is unknown,
ask the IS department for assistance.