PDA User Manual

1-6
PPT 2700 Series Product Reference Guide
2. Connect the cradle to your computer by plugging the serial cable into the serial port
on the back of the cradle, and the other end of the cable into the serial port on your
computer.
Figure 1-5. Connecting the Cradle to the Host Computer
3. Insert the PPT 2700 terminal in the cradle.
Figure 1-6. Inserting the Terminal in the Cradle
4. The Terminal Charge LED turns red to indicate charging, then green when the
battery is fully charged.
Note:
If the cradle is not connected to the host computer via serial cable, the
Terminal Charge LED shuts off when the battery is fully charged.
The terminal’s battery is fully charged after approximately 2 1/2 hours.
Serial Port
Terminal Charge LED