User Manual
Table Of Contents
- ChapterTitleList - Technical Support
- ChapterTitleList - Regulatory Information
- ChapterTitleList - Information to the User
- ChapterTitleList - Table of Contents
- ChapterTitle - About WaveLAN/IEEE
- ChapterTitle - Hardware Installation
- ChapterTitle - Installation for Windows
- ChapterTitle - Advanced WaveLAN Parameters
- ChapterTitle - Monitoring WaveLAN Performance
- ChapterTitle - WaveLAN Security Options
- ChapterTitle - Card Specifications
- ChapterTitle - Troubleshooting
- ChapterTitle - Installing in Windows CE
- ChapterTitle - Installation for MS-DOS
- ChapterTitle - Installing in Apple Macintosh
- ChapterTitle - Warranty Repair Card
- ChapterTitleList - List of Figures
- ChapterTitleList - List of Tables
- ChapterTitleList - Index
Installation for MS-DOS
Install the Network Client Software
WaveLAN IEEE 802.11 PC Card User’s Guide D-9
Install the Network Client Software D
To use the WaveLAN card in a network environment, you will need
to install Network Client software.
If you already had Network Client software installed, you are
advised to remove this software, and run the Network Client
installation program again.
1. Make the directory that contains the Network Client software
the active directory.
For example when installing the Network Client software from
a floppy disk:
a. Insert the disk into floppy drive
A:, and
b. Make drive
A: the active drive.
2. Proceed as described in the User documentation that came
with the Network Client software to start the installation.
3. When prompted to select a driver use the option “Other driver”.
Sometimes this option is referred to as “updated” or “OEM”
driver, or “driver provided by other vendor”.
4. Remove the Network Client software disk from the floppy disk
drive and insert the WaveLAN disk for MS-DOS environments.
5. Follow the instructions as they appear on your screen.