User Manual

Installation for MS-DOS
Finishing Installation
WaveLAN IEEE 802.11 PC Card User’s Guide D-25
Finishing Installation D
To finish the installation insert your IEEE 802.11 WaveLAN PC
Card and restart your computer. Carefully read the messages that
appear on your screen, to verify that:
■ The WaveCAD program executes correctly, and
■ Your computer loads the correct driver parameter settings of
your IEEE 802.11 WaveLAN PC Card.
Correct execution of the WaveCAD program is confirmed with the
message (example):
WaveLAN/IEEE Card Access Driver, Variant X, Version XX.XX
Memory: xxxx, I/O Base: xxxx, IRQ xx
Card Access Driver Installed
Where:
■ XX.XX identifies the version of the WaveLAN Driver
■ xx or xxx identifies the values that you entered upon
installation of the WaveCAD software as described in “Intel
82365 PCIC” on page D-5
A successful load of the WaveLAN Driver is confirmed with either
one of the following messages:
Example WaveLAN DOS ODI Driver:
WaveLAN/IEEE DOS ODI Driver Variant X, v0.0x (yymmdd)
Desired SSID = AAAAAAAAAA
Driver loaded successfully
IRQ xx, Port xxxx, Node Address = xxxxxxxxxxxx L
Max Frame 1514 bytes, Line Speed 2 Mbps, Bus ID 3
Board 1, Frame ETHERNET_802.2, LSB Mode
Where:
■ AAAAAAAAA identifies the WaveLAN Network Name that
you entered in the NET.CFG file,