User Manual
Table Of Contents
- ChapterTitleList - Technical Support
- ChapterTitleList - Regulatory Information
- ChapterTitleList - Information to the User
- ChapterTitleList - Table of Contents
- ChapterTitle - About WaveLAN/IEEE
- ChapterTitle - Hardware Installation
- ChapterTitle - Installation for Windows
- ChapterTitle - Advanced WaveLAN Parameters
- ChapterTitle - Monitoring WaveLAN Performance
- ChapterTitle - WaveLAN Security Options
- ChapterTitle - Card Specifications
- ChapterTitle - Troubleshooting
- ChapterTitle - Installing in Windows CE
- ChapterTitle - Installation for MS-DOS
- ChapterTitle - Installing in Apple Macintosh
- ChapterTitle - Warranty Repair Card
- ChapterTitleList - List of Figures
- ChapterTitleList - List of Tables
- ChapterTitleList - Index
Advanced WaveLAN Parameters
AP Density
WaveLAN IEEE 802.11 PC Card User’s Guide 4-3
AP Density 4
The Access Point Density parameter controls the roaming
sensitivity of your wireless station. This parameter should be set
according to match:
■ The density of the WavePOINT-II access points that have
been installed throughout the wireless network area, and
■ The setting of this parameter in the configuration of the access
points.
Figure 4-2 Access Point Density Parameter
Consult your LAN Administrator for the appropriate values that
apply to your network. Valid values are:
■ Low (default)
■ Medium
■ High
!
CAUTION:
Using non-matching values may seriously affect wireless
performance of your wireless station.