User's Manual

SYMEO Local Positioning Radar System
LPR-1DXi
Product Documentation
Hardware
Copyright © Symeo GmbH 2009
Page 11 of 33
3 Hardware
All corresponding installation, repair and servicing work must be carried out
by qualified and trained technicians.
3.1 Component setup of the LPR-1DXi station
The LPR-1DXi station consists of mounting bracket A, casing with electronic devices B and
antenna C as shown in Figure 3.
Figure 3 Components of the LPR-1DXi: mounting bracket A, casing with electronic devices B and
antenna C
A: mounting bracket
A1 mounting kit for pole and wall mounting
A2 adjustment of elevation angle
A3 adjustment of azimuth angle
B: casing with electronic device
B1 terminal block for relays
B2 terminal block for power connection
B3 terminal block for serial RS232 (distance output, binary protocol)
B4 USB port for parameter setting
B5 cable gland for relay cable to relay connector
B6 cable gland for power supply cable and optional serial RS232 cable
B10 seal
C: Antenna
C1 connector for antenna cable
C2 orientation of antenna polarization
The seal (B10) seals front and rear element when it is mounted
correctly. Otherwise the housing will not be sealed in a water-proof
manner.