User's Manual

SYMEO Local Positioning Radar System
LPR-1DXi
Product Documentation
Commissioning
Copyright © Symeo GmbH 2009
Page 19 of 33
5 Commissioning
5.1 Requirements
In order for a station to be successfully commissioned, the LPR-1DXi stations must have
been installed correctly:
 The station has been installed.
 The station has been connected to the power supply (terminal block B2)
 Relays are connected to your application (terminal block B1)
 Optional: For distance reading RS232 (binary protocol see chapter 6) has been
connected to your application (terminal block B3)
 Configuration software Symeo-Wizard and USB-driver are installed on your Windows PC,
both on product documentation CD delivered with your LPR-1DXi devices.
 Data link to your PC has been established over USB (jack B4)
Once these prerequisites have been fulfilled, you can set parameters with the software
Symeo-Wizard for each station.
5.2 Commissioning Tool – LPR-1DXi Wizard
5.2.1 Installation of USB driver
The USB driver for the LPR-1DXi station is supplied with the product on CD.
Install the USB driver with the executable file CDM20600.exe.
5.2.2 Installation of the Symeo Wizard
Install the LPR-1DXi Wizard .exe file supplied on your product documentation CD on your
computer.
Figure 13 – Installation File
LPR_1DXi_Wizard.exe
Figure 14 – Setup 1