User's Manual

SYMEO Local Positioning Radar System

LPR®-1D24

LPR®-1D24 Station – Overview and Mounting

Mounting and Alignment of LPR®-1D24 Units

LPR-1D24_Users_Manual_FCC-IC-Edition_EN.docx Page 10 of 34

3 Mounting and Alignment of LPR

-1D24 Units

 The device must be secured against falling.

 All mounting, installation and maintenance work must be carried out by

electrician or a person with similar training and skills!

The LPR

-1D24 units are delivered with a separate mounting bracket (see Figure 2).

Figure 2 shows a complete system including the mounting bracket. The bracket must be

mounted with a pipe clamp on a pipe. The pipe diameter is best chosen between 40 mm and

75 mm. For mounting, a flat wrench of SW 13 is required.

For mounting the system, please proceed as follows:

 At a suitable place, mount the LPR

-1D24 unit to a suitable pipe with the bracket. To

adjust the system, do not tighten the mounting bracket finally. Specified alignments have

to be adhered to if indicated by Symeo.

 A minimum distance of 3 meters between the measuring system units must be

maintained to guarantee the specified accuracy. Mounting closer than the minimum

distance decreases the accuracy at close proximity.

 The units must have the same orientation for mounting, for example both units with

connectors downwards. For outdoor use the units have to be mounted with the

connectors downwards.

 Now adjust the system on the opposite side.

 The two system units should be mounted opposite to each other and possibly should not

be an offset horizontal and vertical from each other or twisted.

 Now fix the system by tightening the screws in the mounting bracket and the mounting

bracket on pipe in such a way that no modification is possible anymore. Flat wrench SW

13 is required.

Figure 2: LPR

-1D24 unit inclusive mounting bracket