User's Manual

SYMEO Local Positioning Radar System

LPR®-1D24

LPR®-1D24 Station – Overview and Mounting

General Information

LPR-1D24_Users_Manual_FCC-IC-Edition_EN.docx Page 6 of 34

1 General Information

1.1 Safety Instructions

LPR

-1D24 Systems are purely tracking and assistance systems. They

therefore do not satisfy special requirements for personal safety.

Follow the safety instructions in this documentation!

1.2 Mounting

All mounting, installation and maintenance work must be carried out by

an electrically qualified or trained person!

1.3 Repairs

Repairs on the devices should only be performed by Symeo GmbH.

1.4 Transport and Storage

Use the original packaging or other suitable packaging for returns and

whenever the system is to be transported. This ensures protection from

crushing, impact, moisture and electrostatic discharge.

During setup and before operation, refer to the instructions for

environmental conditions in this document and in the data sheet.

Place the cables in such a way so that they do not build the possible

cause of risk and are not damaged.

1.5 Power Supply

While installing or using it in open-air, the transient overvoltage cannot

be excluded. Here, overvoltage protection is to be used for low voltage

in accordance to DIN EN 61643-21 and IEC 61643-21.

While connecting the plug and sockets, please observe the

correspondent chapter in this document "Specification of Connectors".

Do not use damaged cables (damaged insulation, bare wires). A

defective cable may cause a fire hazard.

Be careful that the device can be damaged with reverse polarity despite

of strict implementation of polarity reversal protection. In that case the

unit must be sent to the SYMEO service for further testing.