User's Manual

SYMEO Local Positioning Radar System

LPR®-1D24

LPR®-1D24 Station – Overview and Mounting

General Information

LPR-1D24_Users_Manual_FCC-IC-Edition_EN.docx Page 7 of 34

1.6 Setup and Operation

During mounting, make sure that no objects or liquids reach inside the

device (risk of short-circuit).

In case of emergency (e.g. damaged housing, control elements or power

cables, penetration of liquids or foreign bodies) switch off the device

immediately, disconnect from the power line the device and inform your

SYMEO service.

Protect the contacts of all sockets and plugs of the device from static

electricity. Avoid touching the contacts. If touching the contacts is

unavoidable, then one should take the following precautions: Touch a

grounded object or wear a ground strap before touching the contacts.

This will dissipate static charges.

The device must be secured against falling.

The LPR

-1D24 unit must not be opened.

1.7 System Extensions and Accessories

Data cables to peripheral devices must be shielded properly.

For LAN cabling, the requirements apply in accordance with EN 50173

and EN 50174-1/2. Use of either a Category 5 shielded cable for 10/100

Ethernet or Category 5e shielded cable for Gigabit Ethernet is a

minimum requirement. The specifications of standard ISO/IEC 11801

must be complied with.

The warranty becomes void in case of any damages caused by

replacement of components on the device during installation.

1.8 Additional Instructions

Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate the

equipment.

1.9 General Requirements for Compliance of Radio Apparatus

This device complies with Part 15 of the FCC Rules and with Industry

Canada license-exempt RSS standard(s). Operation is subject to the

following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.