Safety Instructions
Table Of Contents
- Overview
- System Description
- Hardware
- Installation
- Commissioning
- Web Server
- Protocol Description Binary XP (1D messages)
- Trouble Shooting
- Appendix A: Agency certifications
SYMEO LPR
®
LPR-1D
Product Documentation
Commissioning
Copyright © Symeo GmbH 2010
Page 35 of 87
Data link has been established serially or via TCP/IP.
Once these prerequisites have been fulfilled you can connect the station either serially to a
PC or as an option (TCP/IP option) to the network and commission the LPR
®
1D system.
How to do this is explained in the following chapter.
5.1.1 General
Commissioning is carried out via the serial port or the TCP/IP port depending on the LPR
®
station model you have.
Each LPR
®
unit is equipped with the following interfaces:
An RS232 port for data transmission to downstream systems (PC, S7),
A second RS232 port for parameterization and software updates
Optionally, a TCP/IP port for data transmission and parameterization.
The radio interface at 5.8 GHz for data transmission, communication and measuring with
other LPR
®
units,
The two RS232 ports are incorporated in the Lumberg plug, the radio interface functions via
the system antenna.
RS232 or TCP/IP:
Parameterization
Interface
RS232 or TCP/IP:
Data Interface
Interface Radio Link:
Parameterization,
Distances, User Data
PC, PLC
etc.
Service PC
LPR Unit
LPR Unit
Figure 20: LPR
®
Unit with Interfaces for Parameterization and Protocol Data Interface (Binary
data)