Safety Instructions

SYMEO LPR
®
LPR-1D
Product Documentation
Commissioning
Copyright © Symeo GmbH 2010
Page 47 of 87
At each LPR
®
station an upload must be done.
You can either connect the LPR
®
station direct
to your computer via TCP/IP or serial interface.
Or you have the possibility to get wireless
access via station 1 (coordinator) via the
frequency channel to the other stations
But to get wireless to other stations you have to
know some parameters of the opposite station.
These are the previous group ID, the previous
station number and the antenna port at this
station.
Choose first all parameters and then select the
station number which the station should have
after the upload. Press the Start-button.
A note appears if the uploaded was successful
and the check box is also marked.
If a new application is selected or settings are changed, you have to make
an upload for each LPR
®
station. All checkboxes has to be marked.
Antenna Calibration
After uploading all configuration files to each
LPR
®
station, you have to calibrate the
antennas.



displayed the measured
distance, which is different to
the real distance.
Enter the real distance value between the two


Port 1 is the distance between station 1 and
station 2. If you have a second measurement
then you enter under port 2 the real distance
between station 1 and station 3. The picture
assists you.
The crane is not allowed to
move during the calibration
process.
If the measured distance and the real distance
are not the same after the calibration you might
repeat the calibration.
Duringthe calibration process