Safety Instructions

SYMEO LPR
®
LPR-1D
Product Documentation
Trouble Shooting
Copyright © Symeo GmbH 2010
Page 76 of 87
In two tabs you have to change the settings:
 Tab Display:
- Choose Display As Ansi
- Extend the Rows from 16 to 30
 Tab Port:
- Change the Baud to 115.200
- Choose the right COM port
- Click On Open
Depending if you are connected to a
transponder or a base station characters may
appear in the window.
If you are connected to a transponder a lot of

the transponder tries to make a measurement,
but output a failure because the opposite

failure of measurement. A working system

working measurement.
If you are connected to a base station nothing
is shown.
In both cases you can click inside the window
and press the button 3. If nothing appears than
there is something wrong with the connection
between the LPR-B station and your computer
or the station has no power.
Normally it shows you some system
information:
In the upper line is written the System Address:
The system address indicates if the station is a
transponder or a base station and which group
ID the station has.