Safety Instructions

SYMEO LPR
®
LPR-1D
Product Documentation
Trouble Shooting
Copyright © Symeo GmbH 2010
Page 79 of 87
You should get a reply from the LPR-B station with the fixed IP-address 192.168.1.99
If the connection failed probably your firewall settings of your PC are set to restrictive or the
IP-address of the LPR-B station is probably not 192.168.1.99. Please check the settings.
Compare also the hint in chapter 8.5.1.
If you have changed the IP address without bearing in mind the IP address the IP-address
could be detected with the program NetworkScanner.
8.5.3 Check TCP/IP connection
8.5.4 RealTerm (for parameterization port)
Open now the program RealTerm.
In two tabs you have to change the settings:
 Tab Display:
- Choose Display As Ansi
- Extend the Rows from 16 to 30
 Tab Port:
- Enter the IP-address of the LPR-B station
and the port: IP-address:port
- I.e.: 192.168.1.99:3045
- Click on WinSock is RAW
- Open the connection
Depending if you are connected to a
transponder or a base station characters may
appear in the window.
If you are connected to a transponder a lot of

the transponder tries to make a measurement,
but outputs a failure because the opposite

failure of measurement. A working system

working measurement.
If you are connected to a base station nothing
is shown.