Safety Instructions

Table Of Contents

SYMEO LPR

LPR-1D

Product Documentation

Trouble Shooting

Page 82 of 87

Scroll down to the section:

Serial-to-Ethernet:

Here you enter the connection type

for the parameterization port

(ttyAM1) and the binary port

(ttyAM2).

Both ports should be not disabled.

Choose the right connection type

and enter the data port. The data

port is per default 3045 for the

parameterization port and 3046 for

the binary port.

If you have made changes click on

Upload changes

Reboot system

After the reboot try again to get access to the LPR-B station as described in chapter 8.5.4.

8.6 No Measurements

You can get data on two ports: Parameterization port (S4) which is useful for the setup of the

system and the Binary Port (S2)  compare figure Figure 44). The binary port is necessary if

you want to use the distance data for a system behind the LPR-B system. You will then use

Binary protocol and have to check that the binary port provides proper measurements.

Check List:

1) You have access with the program RealTerm to all stations. (If pressing the button 1

the LPR-B configuration menu is shown.)

2) The antennas are connected to the right port of the LPR-B station.

Transponder

Station 1

Base Station

Station 2

Base Station

Station 3

measurement 1

Antenna an Port