User's Manual
Table Of Contents
- 1 General
- 2 Introduction
- 3 System Description
- 4 Hardware
- 5 Installation
- 6 Coordinate System
- 7 Commissioning
- 7.1 Check list installation and surveying
- 7.2 Editing of configuration files for the DSP
- 7.3 Upload of configuration files for the DSP
- 7.3.1 Connection with LPR mobile unit (type: compact) via TCP/IP
- 7.3.2 Connection with LPR mobile unit (type: compact) via RS232
- 7.3.3 Upload DSP configuration file for LPR mobile unit (base station)
- 7.3.4 Upload DSP configuration file for master transponder unit
- 7.3.5 Upload DSP configuration file for transponder unit
- 7.4 Editing of configuration files for Fusion Engine
- 7.5 Upload configuration files for FusionEngine
- 8 Symeo MAP
- 9 Network Settings
- 10 Symeo 2D Protocol
- 11 Appendix A: Agency certifications
Symeo LPR
®
-System
LPR
®
-2DB
Product Documentation
Symeo 2D Protocol
Copyright © Symeo 2012
Page 123 of 132
ERROR-CODE-3
2
Error code of 3
rd
error
ERROR-VALUE-3
4
Error value of 3
rd
error
UNDERLINE
1
Underline character (ASCII Code 0x5F)
ERROR-CODE-4
2
Error code of 4
th
error
ERROR-VALUE-4
4
Error value of 4
th
error
UNDERLINE
1
Underline character (ASCII Code 0x5F)
ERROR-CODE-5
2
Error code of 5
th
error
ERROR-VALUE-5
4
Error value of 5
th
error
UNDERLINE
1
Underline character (ASCII Code 0x5F)
Entire length of data packet: 38 Byte
A detailed description of all errors is written in chapter 10.6. If there are more than five errors
the special error 0xff is sent as the ERROR-CODE-5.
This data field can be enabled by the following instruction in the configuration file:
[SendSystemError] 1
10.3.3.12 SATELLITE-STATE
This data field is used for satellite-based localization and holds information about the
positioning quality.
Name
Length
Description
SAT
3
ASCII string sat
SAT-COUNT
2
Number of satellites tracked
Character coding: ## (or “-1” for “unknown”)
UNDERLINE
1
Underline character (ASCII Code 0x5F)
SAT-HDOP
4
Horizontal dilution of precision
Character coding: ##.# (or “-1.0” for “unknown”)
UNDERLINE
1
Underline character (ASCII Code 0x5F)
Entire length of data packet: 11 Byte
This data field can be activated in the configuration file via the following line:
[SendSatelliteState] 1