User's Manual
Table Of Contents
- 1 General
- 2 Introduction
- 3 System Description
- 4 Hardware
- 5 Installation
- 6 Coordinate System
- 7 Commissioning
- 7.1 Check list installation and surveying
- 7.2 Editing of configuration files for the DSP
- 7.3 Upload of configuration files for the DSP
- 7.3.1 Connection with LPR mobile unit (type: compact) via TCP/IP
- 7.3.2 Connection with LPR mobile unit (type: compact) via RS232
- 7.3.3 Upload DSP configuration file for LPR mobile unit (base station)
- 7.3.4 Upload DSP configuration file for master transponder unit
- 7.3.5 Upload DSP configuration file for transponder unit
- 7.4 Editing of configuration files for Fusion Engine
- 7.5 Upload configuration files for FusionEngine
- 8 Symeo MAP
- 9 Network Settings
- 10 Symeo 2D Protocol
- 11 Appendix A: Agency certifications
Symeo LPR
®
-System
LPR
®
-2DB
Product Documentation
Symeo 2D Protocol
Copyright © Symeo 2012
Page 128 of 132
10.6.2.5 0x07 – LPR 1D broken
This error is reported if an LPR 1D system is broken (no valid measurement received for
more than 1 second).
10.6.2.6 0xff – more than five errors active
There are currently more than five errors active.
The error value is set to 0xffff.
10.6.3 LPR-B address
LPR-B station addresses are completely defined by a 16 bit value:
15 11 10 1 0
group ID BBstation ID
BB – Base station bit:
Indicates, if the LPR-B station is defined as a basestation or as a
transponder (1=basestation, 0=transponder)
group ID:
Cell ID of the station (1..1022)
station ID:
Station ID of the station (0..30)