User's Manual
Table Of Contents
- 1 General
- 2 Introduction
- 3 System Description
- 4 Hardware
- 5 Installation
- 6 Coordinate System
- 7 Commissioning
- 7.1 Check list installation and surveying
- 7.2 Editing of configuration files for the DSP
- 7.3 Upload of configuration files for the DSP
- 7.3.1 Connection with LPR mobile unit (type: compact) via TCP/IP
- 7.3.2 Connection with LPR mobile unit (type: compact) via RS232
- 7.3.3 Upload DSP configuration file for LPR mobile unit (base station)
- 7.3.4 Upload DSP configuration file for master transponder unit
- 7.3.5 Upload DSP configuration file for transponder unit
- 7.4 Editing of configuration files for Fusion Engine
- 7.5 Upload configuration files for FusionEngine
- 8 Symeo MAP
- 9 Network Settings
- 10 Symeo 2D Protocol
- 11 Appendix A: Agency certifications
Symeo LPR
®
-System
LPR
®
-2DB
Product Documentation
Appendix A: Agency certifications
Copyright © Symeo 2012
Page 130 of 132
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
For Compact Station (mobile unit):
This device has been designed to operate with the antennas listed below.
Antennas not included in this list are strictly prohibited for use with this
device. Only antenna cables delivered by Symeo are allowed to use. Usage
of other antenna cables may void the FCC authorization to operate this
equipment.
6 dBi Omnidirectional Antenna
10 dBi Omnidirectional Antenna
23 dBi Planar Antenna
8,5°
vertical
-3 dB
0 dB
-3 dB
vertical
9°
-3 dB
0 dB
-3 dB
horizontal
9°
-3 dB
0 dB
-3 dB
30°
vertical
-3 dB
0 dB
-3 dB
A
A
A
A = 190mm
d = 20mm
A = 440mm
d = 20mm
B
A = 305mm
B = 305mm
d = 25mm
Antenna Connector Type N
Antenna Connector Type N
Antenna Connector Type N
13 dBi Sector Antenna
horizontal
180°
-3 dB
0 dB
-3 dB
A
d
B
A = 500mm
B = 90mm
d = 80mm
vertical
5°
-3 dB
0 dB
-3 dB
Antenna Connector Type N
Figure 65: LPR
®
1D/ LPR
®
2D antenna