User's Manual
Table Of Contents
- 1 General
- 2 Introduction
- 3 System Description
- 4 Hardware
- 5 Installation
- 6 Coordinate System
- 7 Commissioning
- 7.1 Check list installation and surveying
- 7.2 Editing of configuration files for the DSP
- 7.3 Upload of configuration files for the DSP
- 7.3.1 Connection with LPR mobile unit (type: compact) via TCP/IP
- 7.3.2 Connection with LPR mobile unit (type: compact) via RS232
- 7.3.3 Upload DSP configuration file for LPR mobile unit (base station)
- 7.3.4 Upload DSP configuration file for master transponder unit
- 7.3.5 Upload DSP configuration file for transponder unit
- 7.4 Editing of configuration files for Fusion Engine
- 7.5 Upload configuration files for FusionEngine
- 8 Symeo MAP
- 9 Network Settings
- 10 Symeo 2D Protocol
- 11 Appendix A: Agency certifications
Symeo LPR
®
-System
LPR
®
-2DB
Product Documentation
System Description
Copyright © Symeo 2012
Page 24 of 132
The configuration files are:
LPR-2DB Station (Mobile
unit):
basestation_config.txt
LPR-2DB Integral Station
(Fixed-mounted unit /
transponder):
stationXX0_config.txt
stationXX1_config.txt
stationXX2_config.txt
stationXX3_config.txt
stationXX4_config.txt
stationXX5_config.txt (XX: Cell-ID)
Master LPR-2DB Integral
Station (Fixed-mounted
master unit /master
transponder):
stationxxM_config.txt (XX: Cell-ID)
The settings for the files are described in chapter 7.2.
The access to the LPR-2DB Station can either be done via TCP/IP or via RS232 interface.
The LPR-2DB Integral Station and the master LPR-2DB Integral Station can only be
accessed via the frequency channel of the mobile station.
DSP
LPR-2DB
Integral Station/
Transponder
DSP
Master LPR-
2DB Integral
Station/ Master
Mobile unit/ base station
ARM9
DSP
RS232
User
RS232 Service
TCP/IP
User & Service
RS232
User & Service
access via radio
channel (FSK channel)
access via
TCP/IP or
serial interface
access via radio
channel (FSK channel)
Figure 7 – LPR units including DSP: Access to the DSP via TCP/IP, RS232 or frequency
channel
In chapter 7.3 all different connections to the LPR stations are described. To configure the
connection via TCP/IP web interface exists (chapter 0).
3.4.1 2D Positioning
Each mobile unit calculates the distance of its antennas to each LPR-2DB Integral Station/
transponder. A positioning does not happen in this moment, only the calculation of 6 single
1D distance measurements.