User's Manual
Table Of Contents
- 1 General
- 2 Introduction
- 3 System Description
- 4 Hardware
- 5 Installation
- 6 Coordinate System
- 7 Commissioning
- 7.1 Check list installation and surveying
- 7.2 Editing of configuration files for the DSP
- 7.3 Upload of configuration files for the DSP
- 7.3.1 Connection with LPR mobile unit (type: compact) via TCP/IP
- 7.3.2 Connection with LPR mobile unit (type: compact) via RS232
- 7.3.3 Upload DSP configuration file for LPR mobile unit (base station)
- 7.3.4 Upload DSP configuration file for master transponder unit
- 7.3.5 Upload DSP configuration file for transponder unit
- 7.4 Editing of configuration files for Fusion Engine
- 7.5 Upload configuration files for FusionEngine
- 8 Symeo MAP
- 9 Network Settings
- 10 Symeo 2D Protocol
- 11 Appendix A: Agency certifications
Symeo LPR
®
-System
LPR
®
-2DB
Product Documentation
Hardware
Copyright © Symeo 2012
Page 33 of 132
4.5 LPR-2DB Integral Station (fixed mounted unit)
Following hardware exists for an LPR-2DB Integral Station on the light poles:
TPB000250 (LPR-2DB Integral)
TPB000251 (LPR-2DB Integral)
TPB000530 (LPR-2DB Integral, cell coordinator)
The electronics inside LPR-2DB Integral Station hood itself do not
include any components that can be serviced by the user. They must
not be detached from the hood because they contain parts that are
electrically charged inside when connected to the LPR-2DB Integral
Station base.
All corresponding installation, repair and servicing work must be carried
out by qualified and trained technicians.
If the LPR-2DB Integral Station is installed on a pole, it must be secured
to ensure that it does not slip.
If the direct current is incorrectly connected, the LPR-2DB Integral
Station will be damaged and must be returned to the SYMEO service for
further inspection.
The plugged connection between the LPR-2DB Integral Station hood
and base provides protection against direct contact, i.e. it can be
connected and disconnected while it is under load.
Refer to the general design notes regarding your LPR system.
4.5.1 Technical Data: LPR-2DB Integral Station
Technical Data
Power draw
4W, 10-36VDC
Dimensions (LxWxH)
212 (incl. mounting bracket) x 126 x 281 mm
Type of protection
IP 65 with feasible cables according to the cable gland
Antenna
Integrated inside the housing
Compliance
CE mark