User's Manual
Table Of Contents
- 1 General
- 2 Introduction
- 3 System Description
- 4 Hardware
- 5 Installation
- 6 Coordinate System
- 7 Commissioning
- 7.1 Check list installation and surveying
- 7.2 Editing of configuration files for the DSP
- 7.3 Upload of configuration files for the DSP
- 7.3.1 Connection with LPR mobile unit (type: compact) via TCP/IP
- 7.3.2 Connection with LPR mobile unit (type: compact) via RS232
- 7.3.3 Upload DSP configuration file for LPR mobile unit (base station)
- 7.3.4 Upload DSP configuration file for master transponder unit
- 7.3.5 Upload DSP configuration file for transponder unit
- 7.4 Editing of configuration files for Fusion Engine
- 7.5 Upload configuration files for FusionEngine
- 8 Symeo MAP
- 9 Network Settings
- 10 Symeo 2D Protocol
- 11 Appendix A: Agency certifications
Symeo LPR
®
-System
LPR
®
-2DB
Product Documentation
Coordinate System
Copyright © Symeo 2012
Page 54 of 132
Port
Antenna port of the connected antenna. (0) means antenna
port 1, (1) means antenna port (2) etc.
x
x-position of the antenna at the connected port in
coordinates of the vehicle. Specification is in meters and with
3 decimal numbers.
y
y-position of the antenna at the connected port in
coordinates of the vehicle. Specification is in meters and with
3 decimal numbers.
height
Height of the antenna over ground. Specification is in meters
and with 3 decimal numbers.
LoadPosition
Operation point ; e.g. center of spreader (x, y, z)