User's Manual
Table Of Contents
- 1 General
- 2 Introduction
- 3 System Description
- 4 Hardware
- 5 Installation
- 6 Coordinate System
- 7 Commissioning
- 7.1 Check list installation and surveying
- 7.2 Editing of configuration files for the DSP
- 7.3 Upload of configuration files for the DSP
- 7.3.1 Connection with LPR mobile unit (type: compact) via TCP/IP
- 7.3.2 Connection with LPR mobile unit (type: compact) via RS232
- 7.3.3 Upload DSP configuration file for LPR mobile unit (base station)
- 7.3.4 Upload DSP configuration file for master transponder unit
- 7.3.5 Upload DSP configuration file for transponder unit
- 7.4 Editing of configuration files for Fusion Engine
- 7.5 Upload configuration files for FusionEngine
- 8 Symeo MAP
- 9 Network Settings
- 10 Symeo 2D Protocol
- 11 Appendix A: Agency certifications
Symeo LPR
®
-System
LPR
®
-2DB
Product Documentation
Commissioning
Copyright © Symeo 2012
Page 57 of 132
(only Mode 2 and 3 –
master transponder)
No modification necessary for mode 1, 2a and 3a
stationXX#_config.txt
(all transponders)
No modification necessary
The “XX”-sign replaces the Cell number of the master transponders, the
„M“-sign indicates the master station-ID 30. The “XX”-sign replaces the
Cell number of the transponders, the „#“-sign the station-ID.
7.2.1 File basestation_config.txt
This file is preconfigured by delivery and needs no changes.
7.2.2 File stationXXM_config.txt
This file for the master transponder only exists in mode 2b (Managed
cell) and mode 3b (TDOA). In mode 1 (Basic cell) the base station(s)
organize(s) the measurements and the master transponder is not be
applied. In 2a and 3a a file XXM_config.txt exists but no changes of this
file should be done.
Figure 38 – Entry of transponder coordinates in the file XXM_config.txt (only mode 2b and
3b)