User's Manual

Symeo LPR
®
-System
LPR
®
-2DB
Product Documentation
Commissioning
Copyright © Symeo 2012
Page 67 of 132
Figure 49
 Press button 4 in the
window of the terminal
program to open the “LPR B
Configuration Menu”.
 Press button 4 in the
window of the terminal
program for “Upload
Configuration”.
 Change to tab “Send”
 Choose the path and your
file for the transponder
(Station??x_config.txt).
 Press the “Send File”-
button. Wait a moment until
the transponder responses.
A successful upload is
confirmed in the terminal
window.
7.4 Editing of configuration files for Fusion Engine
The software FusionEngine is the central unit for calculating the 2D position. Either it runs
internally on the mobile unit (ARM9 on the LPR-2DB Compact Station) or it runs on a
separate PC.
If using the mobile unit (ARM9), the FusionEngine is already pre-configered and only a few
adaptations must be made. If it runs on an extern PC some more configuration is required.
The following files and contents exist and must be checked and modified by the customer:
File
Change(s)
fusion.ini
If running on mobile unit: no changes.
If running on extern PC:
Measurement path and connection parameters must be set
field.ini
Only with operation mode 1, 2a and 3a:
Transponder coordinates must be entered.
With the other operation modes (2b, 3b) the transponder
coordinates are saved in the master transponder.
LPR_B.ini
(LPR_B1.ini and
LPR_B2.ini)
Antenna positions (in vehicle coordinates) of the mobile unit
antennas.
Only with operation mode 1, 2a and 2b: antenna cable length.
Single receiver: LPR_B.ini
Double receiver: LPR_B1.ini and LPR_B2.ini