User's Manual
Table Of Contents
- 1 General
- 2 Introduction
- 3 System Description
- 4 Hardware
- 5 Installation
- 6 Coordinate System
- 7 Commissioning
- 7.1 Check list installation and surveying
- 7.2 Editing of configuration files for the DSP
- 7.3 Upload of configuration files for the DSP
- 7.3.1 Connection with LPR mobile unit (type: compact) via TCP/IP
- 7.3.2 Connection with LPR mobile unit (type: compact) via RS232
- 7.3.3 Upload DSP configuration file for LPR mobile unit (base station)
- 7.3.4 Upload DSP configuration file for master transponder unit
- 7.3.5 Upload DSP configuration file for transponder unit
- 7.4 Editing of configuration files for Fusion Engine
- 7.5 Upload configuration files for FusionEngine
- 8 Symeo MAP
- 9 Network Settings
- 10 Symeo 2D Protocol
- 11 Appendix A: Agency certifications
Symeo LPR
®
-System
LPR
®
-2DB
Product Documentation
Commissioning
Copyright © Symeo 2012
Page 74 of 132
7.5.1.1 Step 1 – Connecting
Start WinSCP and a login
screen will appear. Enter
connection parameters like
the IP-address ('Host
name', e.g. 192.168.1.99),
user name ('symeo') and
password (default
password: '54all2u').
After optionally saving the
connection parameters
('Save…'), press 'Login' in
order to establish a
connection. For the first
time connecting to the
remote machine, the server
host key must be stored
pressing 'Yes' in the
following dialog box.
7.5.1.2 Step 2 – Browsing the file system
You are now connected to the remote station's file system. Keep in mind, that only the path
'/mnt/user3/' is located in a persistant memory location (Flash memory), whereas all other
folders are located in the volatile memory (Ram) and changes will be lost during restart.