User's Manual
Table Of Contents
- 1 General
- 2 Introduction
- 3 System Description
- 4 Hardware
- 5 Installation
- 6 Coordinate System
- 7 Commissioning
- 7.1 Check list installation and surveying
- 7.2 Editing of configuration files for the DSP
- 7.3 Upload of configuration files for the DSP
- 7.3.1 Connection with LPR mobile unit (type: compact) via TCP/IP
- 7.3.2 Connection with LPR mobile unit (type: compact) via RS232
- 7.3.3 Upload DSP configuration file for LPR mobile unit (base station)
- 7.3.4 Upload DSP configuration file for master transponder unit
- 7.3.5 Upload DSP configuration file for transponder unit
- 7.4 Editing of configuration files for Fusion Engine
- 7.5 Upload configuration files for FusionEngine
- 8 Symeo MAP
- 9 Network Settings
- 10 Symeo 2D Protocol
- 11 Appendix A: Agency certifications
Symeo LPR
®
-System
LPR
®
-2DB
Product Documentation
Symeo MAP
Copyright © Symeo 2012
Page 78 of 132
8 Symeo MAP
Symeo MAP is the software package for visualizing and monitoring LPR systems. The
movement of a single base station and the status of the entire system is available at a click.
Symeo MAP requires a PC (Windows XP or Vista), that can access the LPR base station
(the computer were FusionEngine runs) via a TCP/IP connection. Symeo MAP can connect
to any base station to display the current position and the quality of the position
measurement.
8.1 Configuration and Connection with Symeo MAP
8.1.1 lpr.ini
The file lpr.ini must be modified for commissioning of Symeo MAP. This file contains the
connection parameters (hostname and ports) of the mobile units.
The file lpr.ini can either be opened in the installation directory of Symeo MAP or by open the
software Symeo MAP:
Open the file Symeo_MAP.exe
Cancel the following dialog: “Select
connection”.
Click in „Base station“
Click on „Edit file lpr.ini“
The file LPR.ini is opened in text
editor. After modification save the
changes and close the file.
Here only the TCP/IP address
and port must be entered. The
port must be consistent with the
port entered in the file fusion.ini
(see 7.4.1). Default port is
7777.
Allocate a name for the Fusion Engine, i.e. Station_A or forklift1.