Installation Sheet

FIBERGLASS WALL
INSTALLATION
When installing Visu-Temp in fiber-
glass or panel walls and it is desired
to sandwich wall between valve
body and escutcheon, cut hole in
wall as shown in Figure 4 and mount
valve from rear. NOTE: IT IS ALWAYS
RECOMMENDED TO SECURE VALVE
PIPING TO ROUGH CONSTRUCTION
AND NOT DEPEND ON FIBERGLASS
WALL FOR VALVE MOUNTING SECU-
RITY. On panel walls over 1” thick,
install in conventional manner. (See
figure 1).
OPERATION OF VALVE
The main handle of the Visu-Temp
valve is for control of temperature
only. From the OFF position, the
handle is turned counter-clockwise
through a minimum cold position,
through a warm and hot position for
a maximum turn of approximately
one revolution. This allows for infi-
nite temperature adjustments to suit
the requirements of any user.
CARE AND CLEANING
The lustrous finish on your Visu-Temp
valve should be treated with care. It
can be readily damaged by improper
handling or abusive treatment. To
clean the finish wipe gently with a
soft damp cloth and blot dry with a
soft towel. Use only a mild soap solu-
tion if required. DO NOT USE ABRA-
SIVE CLEANERS. USE OF POLISH,
ABRASIVE CLEANERS, SOLVENTS OR
ACID CLEANERS WILL DAMAGE THE
FINISH AND VOID THE SYMMONS
WARRANTY.
INDIVIDUAL PARTS
C-5 Spindle assembly
C-32-11 Spindle assembly
C-32B-11 Plaster shield
SC-2 Cap
SC-3 Renewable seat
SC-7 Packing nut with o-rings
SC-9 Cold washer retainer
SC-10A Hot washer screw
SC-10/11 Hot and cold washers
SC-13/18 Dome cover and lock nut
SC-15A Handle screw
SC-17 Packing
SC-19 Cap gasket
SC-20A/21 Top seat O-ring & bottom seat
gasket
SC-26 Limit stop with o-ring
SC-126 Plaster shield
VT-9A Retainer assembly
VT-105 Escutcheon assembly
VT-103 Thermometer assembly
VT-104 On/Off indicator assembly
VT-112 Handle
VT-114 Escutcheon gasket
VT-115 Dome cover gasket
WO-20A Escutcheon screws (2)
Washer & Gasket KIT-B-VT
SC-9 Cold washer retainer
SC-10A Hot washer screw
SC-10/11 Hot and cold washers
SC-15 Handle screw
SC-17 Packing
SC-19 Cap Gasket
VT-9A Retainer assembly
VT-114 Escutcheon gasket
Repair units
SC-3 Renewable seat unit complete
C-50 Renewable seat socket wrench
(not shown)
C-5 SpindleC-5 Spindle assembly
COMPOSITE PARTS
SC-13
VT-112
SC-15A
VT-105
VT-115
VT-114
VT-103
WO-20A
VT-104
SC-7
SC-17
SC-26
SC-19
SC-10/11
C-5
SC-20A-20
C-32-11
VT-9A
SC-10A
SC-3
C-32 B-11
SC-9
SC-2
SC-126
TO BE DISCARDED BEFORE INSTALLING TRIM