Specification Sheet
SYMMONS PRODUCTS MEET
ANSI A112.18.1M, EPA ‘92
AND ALL KNOWN FLOW RATE
REQUIREMENTS.
Shower Heads and Hand Showers
2.5 GPM (9.5 L/min)
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184
(800) 796-6667, (781) 848-2250 ■ Fax (800) 961-9621, (781) 843-3849
Website: www.symmons.com ■ Email: customers er vi ce @s ym mo ns .c om
©2003, 2008 Symmons Industries, Inc. Printed in U.S.A. ■ 050108
Job/Location
. . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
Engineer
. . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
Contractor
. . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
This drawing to be used for rough-in installation
only. All floor to center dimensions optional.
Concealed piping and fittings not furnished by
manufacturer. For ADA compliance (Americans
with Disabilities Act) consult ADAAG or your
state regulations for proper product choice and
mounting locations. For complete installation,
adjustment and service information see installa-
tion instructions.
1-500VT-H401-V
Visu-Temp
®
Tub and
Shower System with
Hand Spray
Visu-Temp Pressure-Balancing mixing valve with Clear-Vue™
thermometer and adjustable stop screw to limit handle turn. Tub spout.
Lever diverter with volume control for hand spray and tub spout. Euro-
Flo single mode wall/hand shower with flexible 5’ metal hose, in-line
vacuum breaker, wall connection and flange. Cradle for hand shower
mounting. Polished chrome finish.
Modifications:
Suffix BRS: Radiance
®
polished brass finish
Suffix PCB: Polished chrome and Radiance
®
polished brass finish
Suffix STN: Radiance
®
satin finish
Suffix X: Integral service stops—allows water shut-off at valve for service
Suffix X-3/4 3/4” valve to increase flow approximately 20%
NOTE: 2-1/2” (64mm) min.
3” (76mm) max. On 2”x4”
construction, use 2-1/2”
(64mm) min. rough-in.
Valve inlets and outlets are
1/2” (13mm) IPS connections.
Male 1/2” I.P.S. thread must be recessed 1/4“ (6mm) from
nished wall for proper installation of street ell and ange.