Installation Sheet

6
1a) Dry Wall Option: Remove upper and lower caps
from slide bar brackets. Place slide bar into desired
position. Using brackets as a guide, carefully drill 3/16"
holes into wall. Remove slide bar and install anchors.
Note: Slide bar holes and bracket holes must be
aligned before drilling. Before drilling bottom hole,
make sure slide bar is plumb (FIGURE 10.1A).
1b) Stud Option: Remove upper and lower caps
from slide bar brackets. Place slide bar into
desired position. Using brackets as a guide,
carefully drill 1/8" pilot holes into stud.
Note: Slide bar holes and bracket holes must be
aligned before drilling. Before drilling bottom hole,
make sure slide bar is plumb (FIGURE 10.1B).
2) With slide bar in position, secure to wall using screws.
Replace upper and lower caps onto slide bar brackets
(FIGURE 10.2).
3) Install wall elbow to stub out pipe. Tighten set screw to
secure (FIGURE 10.3).
4) Attach small end of hand shower hose to wall elbow.
Turn clockwise to tighten (FIGURE 10.4).
1
2
3
FIGURE 10.1A
FIGURE 10.3
FIGURE 10.4
FIGURE 10.1B
1
2
1 3
2
FIGURE 10.2
10. Installation - Slide Bar Assembly
5) Attach large end of hand shower hose to hand shower
wand. Turn clockwise to tighten (FIGURE 10.5).
FIGURE 10.5