Installation Guide

5
Installation
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ [phone] ■ Fax: [phone]
©2014 Symmons Industries, Inc. ■ www.symmons.com ■ [e-mail] ■ ZV-3055 REV 0 09/04/14
9) Place mounting plate (P2) in
position, mark and drill 1/8" pilot
holes into stud.
Option: Place mounting plate (P2) in
position, mark and drill 3/16" holes
into wall. Install anchors.
10) Install mounting plate (P2) .
Secure with two screws (Q) .
Replace cradle mount cover (P1).
Note: Mounting plate (P2) center
tabs must be horizontal for
installation.
11) Attach cradle arm (S) and
washer (R) to cradle mount (P).
Secure with set screw (T).
12) Attach shower arm (E) and ange
(F) to vertical shower pipe turning
clockwise to tighten.
13) Install showerhead (D) to shower
arm (E) turning clockwise to
tighten.
14) Attach large end of hand shower
hose (X) to hand shower (V).
Attach small end of hand shower
hose (X) and gasket to in-line
vacuum breaker (A). Connect
in-line vacuum breaker to wall
elbow (B). Turn clockwise to
tighten.
1
3
2
P2
1
3
2
Q
P2
P2
P1
3
1
4
2
X
V
A
X
B
1
2
D
E
1
2
E
F
1
2
P2
1
2
P
T
R
S