Specification

Identity
™
Model Numbers
Hand Shower System
Specification Submittal
6703
Hand shower system powered by the Temptrol
®
pressure-
balancing valve. Features adjustable stop screw to limit
handle turn, wall elbow, in-line vacuum breaker, 60" exible
metal hose, hand shower cradle, 1 mode hand shower and
standard 2.5 gpm (9.5 L/min) ow restrictor. Components
made from metal and nonmetallic materials, plated in
standard polished chrome nish.
Specification
Location:
Warranty
Limited Lifetime - to the original end purchaser in
consumer/residential installations.
5 Years - for industrial/commercial installations.
Refer to www.symmons.com/warranty for complete
warranty information.
Compliance
Modifications
Note: Append appropriate -sufx to model number.

6703
Identity Hand Shower System
-ASME A112.18.1/CSA B125.1
-WaterSense 1.5 gpm (5.7 L/min)
2.0 gpm (7.6 L/min)
Certied by
CSA Group

-1.5 1.5 gpm (5.7 L/min) flow restrictor

-2.0 2.0 gpm (7.6 L/min) flow restrictor

-72
6' metal hose in place of 5' standard
metal hose

-B30
30" slide bar in place of wall cradle

-B48
48" slide bar in place of wall cradle

-CHKS Integral check stops - for use in
installations where a positive shut-off
device is used downstream of mixing valve

-IPS 1/2" female IPS connections

-L/HS
Less hand shower

-LP Loop handle

-LR Lever handle

-OP 13" oval plate

-QD
Quick disconnect on hand shower units

-R
White vinyl hose in place of metal hose

-REB-TRM
Rebuild trim kit

-REV Reverse coring, hot on right, cold on
left, for back to back installations

-STN Satin Nickel finish

-T724 24" slide / grab bar with ADA hand
shower in place of standard hand
shower unit

-T736 36" slide / grab bar with ADA hand
shower in place of standard hand
shower unit

-TRM Trim only, valve not included

-X Integral service stops - allows water
shutoff at valve for service