Installation Guide

5
Installation
Operation (Temperature Control)
1) Turn shower handle counter-
clockwise approximately 1/4 turn
to put valve in cold position.
2) Turn shower handle counter-
clockwise approximately 1/2 turn
to put valve in warm position.
3) Turn shower handle counter-
clockwise approximately 3/4 turn
to put valve in hot position.
Operation (Diverter Control)
1
3
C
4
T2
T3
T1
T2
2
Note: For dry wall 1/2" thick or less,
insert anchor tool (T3) into drywall
anchor (T2) to secure behind wall
prior to installing wall cradle.
9) Place mounting plate (C) in
position, mark and drill 3/16" holes
for tile anchors (T1), 5/16" holes
for drywall anchors (T2). Install
anchors.
10) Remove cover of hand shower
cradle (E) . Install cradle and
mounting plate (C) . Secure with
three screws (F) . Replace cover
on hand shower cradle.
1
2
4
E
F
C
3
11) Attach vacuum breaker (G) to wall
ell (B). Attach hose (H) to vacuum
breaker. Attach hand shower (A)
to hose (H). Turn clockwise to
tighten.
5
3
1
2
4
A
H
H
G
B
POSITION 1
POSITION 2
POSITION 3
1) Cartridge is factory set to divert to
function 1.
2) Turn handle to position 2 to divert
to function 2.
3) Turn handle to position 3 to share
functions 1 and 2.
Note: In this position there is no detent.