Installation Sheet

BACK TO BACK INSTALLATION
To simplify piping on back to back installations use one stan-
dard valve (hot on left, cold on right) and one with reverse
coring (hot on right, cold on left) as shown in Figure 6 and
7. Order reverse core valve by adding the suffix REV-X
after the plate number. (e.g. C-96-2-REV-X Temptrol
®
tub and
shower unit with reverse coring.)
OPERATION OF VALVE
The main handle of the Temptrol
®
valve is for control of
temperature only. From the OFF position, the handle is
turned counter-clockwise through a minimum cold position,
through a warm and hot position for a maximum turn of
approximately one revolution. This allows for wide range of
temperature adjustments to suit the requirements of any user.
CARE AND CLEANING
The lustrous finish on your Temptrol valve should be treated
with care. It can be readily damaged by improper handling or
abusive treatment. To clean the finish wipe gently with a soft
damp cloth and blot dry with a soft towel. Use only a mild
soap solution if required. DO NOT USE ABRASIVE CLEAN-
ERS. USE OF POLISH, ABRASIVE CLEANERS, SOLVENTS
OR ACID CLEANERS WILL DAMAGE THE FINISH AND
VOID THE SYMMONS WARRANTY.
inlets
hot and cold
shower 
discharge
finished wall
COLD
tub discharge
1
2
''
6
1
4
''
REVERSE
CORE VALVE
STANDARD
VALVE
2
13mm
70mm 13mm
3
4
''
159mm
MINIMUM WALL
THICKNESS
1
2
''
+
2
51mm 13mm
''
1
2
''
+
2
57mm 13mm
1
4
''
1
2
''
+
NOTCH
T-35A
T-35
B
EIGHT BROACHED NOTCHES
TO ENGAGE FOUR CORNERS
OF COLD SEAT TOOL IN TWO
POSITIONS.
FOUR BROACHED
NOTCHES TO
ENGAGE FOUR
CORNERS
OF HOT SEAT
TOOL.
FIGURE 7
Back to Back Installation
FIGURE 8
Seat Removal Tools
HOT
COLD
COLD
HOT
FIGURE 6