Installation Sheet

3
Installation
Water lines MUST be thoroughly ushed BEFORE and AFTER installing the faucet to prevent foreign matter i.e.
copper chips, sand, stones, etc. from clogging and possibly damaging the sealing surfaces of the cartridge.
1) Press deck ange (M) against faucet
body (G).
2) Install faucet body (G), supply hoses
and pull-down hose to deck surface.
3) Install rubber washer (Q), metal
washer (R) and mounting nut (S) to
faucet body (G). Secure to bottom
of deck with 3x mounting screws (T).
G
G
Q
S
R
T
4) Attach outlet end of pull-down
hose (V) to hose adapter (U).
Press tab on hose adapter (U) to
disconnect as shown above.
5) Attach counterweight (X) to outlet end
of pull-down hose. Counterweight
should be placed above the hose
loop. Secure with 2x screws (W).
6) Connect hot supply hose (red stripe)
and cold supply hose (blue stripe) to
supply outlets.
X
X
W
W
HOT
SUPPLY
COLD
SUPPLY
G
P
INSTALLATION TIP:
O-RING (P) WILL
COME ATTACHED TO
DECK FLANGE (M)
M
U
V
PRESS TAB
TO DISCONNECT
7) Remove spray wand (J) from
pull-down hose coupling (F).
8) Turn on water supplies to ush lines.
JJ
F
9) Turn handle (O) slowly toward you
and then away. Check for leaks.
3
1
2
O