Installation Guide

3
H
J
K
2) Place brackets (L) onto threaded
rods (J). Secure with nuts (M).
1
1
2
M
L
J
If replacing an older faucet
ensure water supply is turned
OFF before removing, then
turn faucet control valve ON to
relieve water pressure.
1) Insert hoses from faucet body
(H) and threaded rods (J) through
mounting gasket (K) and sink
holes.
3) Seat ange (N2) into sink (N3
gasket optional). Install gasket
(N4), washer (N5) and nut (N6)
onto ange (N2) from below sink,
but do not secure nut. Screw on
tail piece (N7) and hand tighten.
2
3
N2
N7
PLUMBER
PUTTY
OPTIONAL
N3
N4
N5
N6
4) Turn tail piece (N7) and ange
(N2) so pivot is facing toward
faucet. Pull assembly down into
drain hole. Secure hardware from
below sink. Install stopper (N1) in
the removable or non-removable
position.
2
3
N7
PIVOT
N2
N1
5) Attach inner washer (N8), pivot rod
(N9) and outer washer (N10) to tail-
piece (N7). Hand tighten nut (N11)
to secure pivot rod (N9).
N9
N7
1
N8
N10
N11
2
6) Connect lift rod (F) to clevis strap
(N13) and secure with thumb
screw (N14). Insert pivot rod
(N9) through spring clip (N12)
and clevis strap (N13). Secure
with spring clip (N12) and adjust
linkage if necessary.
3
4
4
N12
N9
N13
2
N14
N13
1
F
Installation