Installation Sheet

5
FIGURE 8.4
8. Installation - Shower Valve Trim
2) Place diverter/volume control handle into slot in shower
escutcheon (FIGURE 8.2).
3) Secure large shower escutcheon to mounting plate.
Guide handle into control port on valve body. Tabs
should snap in place (FIGURE 8.3).
FIGURE 8.1
FIGURE 8.2
FIGURE 8.3
1) Attach arm and flange to shower pipe. Turn clockwise
to tighten (FIGURE 9.1).
2) Install showerhead to shower arm. Turn clockwise to
tighten (FIGURE 9.2).
9. Installation - Showerhead & Tub Spout
FIGURE 8.5
1) Secure large mounting plate to Temptrol
pressure balancing valve using mounting screws
(FIGURE 8.1).
3) Install tub spout escutcheon and tub spout to
stub out pipe. Turn clockwise to tighten (FIGURE 9.3).
4) Install dome cover and lock nut by turning clockwise
(FIGURE 8.4).
5) Install flange and handle to shower valve. Secure set
screw (FIGURE 8.5).
FIGURE 9.1 FIGURE 9.2
FIGURE 9.3