Installation Guide

Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ Phone: [phone] ■ Fax: [phone]
Copyright © 2016 Symmons Industries, Inc. ■ symmons.com ■ [e-mail] ■ ZV-3216 REV 0 ■ 081516
Problem Cause Solution
Faucet runs too long or too short.
Cycle timing washers have not been
adjusted.
Remove handle (A) then add cycle timing
washers (C) to stem to shorten time or
remove washers to lengthen time.
Faucet drips.
Seat washer worn or foreign matter
(chips, dirt, solder, etc.) is between
washer and seat surface.
Disassemble cartridge (H) and remove
piston* (H6). Remove screw (H7) and
clean seat washer (H8). Check control
rod pin (H9) for burr then reassemble.
Faucet runs constantly.
Seat washer not closing on seat surface
or seat washer and/or seat surface is
worn.
Remove piston (H6) and spring** (H12).
Check for burr on pin (H9) and check
spring. Both piston and spring may
have to be replaced. Excessive wear
may require cartridge (H) replacement.
Water leaks from under handle. Stem washers worn.
Remove cartridge (H) and replace with
housing o-rings (G1). If leak persists
replace control spindle kit (H1).
Faucet leaks on or under counter. Supply housing o-rings worn. Replace housing o-rings (G1).
Faucet bleeding between hot and cold. LL-71B check/screens NOT installed.
Two chrome plated 3/8" check/screens
are supplied with every faucet and
MUST be installed.
Faucet bleeding between hot and cold. LL-71B check/screens ARE installed. Replace check springs (K,L).
Handle is loose. Set screw has loosened. Tighten set screw (B).
Handle is sticking to cartridge. Accumulation of sediment in cartridge.
Remove handle (A) and all cycle timing
washers (C) from cartridge (H). Secure
handle back onto cartridge. After mov-
ing handle to the hot position, cycle
faucet by pressing down on handle.
Cycle faucet 12 times. Remove handle
and replace timing washers.
Finish is spotting.
Elements in water supply may cause
water staining on nish.
Clean nished trim area with a soft
cloth using mild soap and water or a
non-abrasive cleaner and then quickly
rinse with water.
Troubleshooting Chart
Notes: *1) Use caution not to damage piston quadring (H10) while servicing piston assembly (H6).
**2) Do not squeeze ends of spring (H12) causing spring to fully compress.
For California Residents
WARNING: This product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.