Installation Sheet

3
Installation
1) Insert faucet body (E) through
deck surface.
2) Slide mounting gasket (G) and
metal washer (H) on to fasteners (X).
Secure with mounting nuts (I).
Note: Hoses removed for clarity.
3) Install plumber tape to inlets of
shut-off valves. Attach supply lines
to shut-off valves and hand tighten.
Using a wrench, nish with one-
half turn. DO NOT overtighten.
4) Apply plumber putty to underside
of ange (L).
5) Insert ange (L) into drain
opening. From below, attach
drain body (Q) with gasket (M)
and washer (N) to ange (2-3
turns until hand tight).
Note: Make sure drain cavity (on
drain body) faces rear of sink.
6) From below, tighten ange nut (O)
to secure drain body (Q).
DO NOT overtighten.
Note: Make sure ange is centered
in drain opening.
7) Insert stopper (K) into ange (L)
and rotate to proper position.
Note: Stopper can be installed
removable or non-removable
determined by eye hole position.
1
2
G
X
H
I
1
1
2
E
L
3
1
2
L
Q
M
N
OPTIONAL
O
Q
K
Non Removable
K
L
Removable
K
Removable
Optional: Adjust limit stop washer
to limit handle turn to the
hot position if desirable.
2
1
3
_
+