Installation Guide

ManualsBrandsSymmons ManualsBathroom Sink FaucetsWinslet Satin Nickel 2-handle Widespread WaterSense Bathroom Sink Faucet with Drain

Non-

Removable Removable

Stopper Stopper

Quick Install Guide Allura Widespread Lavatory Faucet, SLW-4712

Step 1

Attach control valves to sink

Step 1

Attach center spout to sink

Step 2

Attach pivot rod to drain body

Step 6

Connect lift rod, clevis strap,

pivot rod and adjust linkage

Step 7

Install stopper and

set eye position

Step 5

Flush water supply lines

Step 9

Attach drain body to drain trap

Step 8

Step 3

SConnect water supply lines

Fasten drain body and

tail piece to sink

Step 4

Tools & Materials

 Need Help?

Contact Symmons customer service at

(800) 796-6667, (781) 848-2250

Email: customerservice@symmons.com

Monday - Friday 7:30 am - 7:00 pm EST

 Please check Symmons website

for technical help, the latest product

information and warranty policy.

www.symmons.com/service

Widespread Lavatory Faucet SLW-4712

Installation and Service Instructions

Allura

Model Numbers

SLW-4712

Lavatory faucet with

pop-up drain

Note: Instructions replace document

ZV-782 as of June 2012.

Alternate Finish Code

append to part numbers when applicable

-STN

Satin Nickel

Chrome (standard)

Compliance

- ASME A112.18.1/CSA B125.1

- NSF/ANSI 61.9, NSF/ANSI 372

- WaterSense 1.0 & 1.5 gpm

Certied by

NSF International

Plumbers

Putty

Pipe

Sealant

5/64"

Summary of content (4 pages)

PAGE 1
Allura® Widespread Lavatory Faucet SLW-4712 Installation and Service Instructions Tools & Materials Model Numbers SLW-4712 Lavatory faucet with pop-up drain e Pip nt la Sea  Need Help? 5/64" Plumbers Putty Note: Instructions replace document ZV-782 as of June 2012.  Compliance Alternate Finish Code append to part numbers when applicable -STN Satin Nickel -- Chrome (standard) Contact Symmons customer service at (800) 796-6667, (781) 848-2250 Email: customerservice@symmons.
PAGE 2
Installation Instructions Caution: If replacing an older faucet ensure water supply is turned OFF before removing. Then turn both faucet handles to the ON position to relieve water pressure. Step 1 Attach control valves to sink ■■ Thread flange nut down about 2 inches from threaded end of valve body. ■■ Insert valve body from underneath sink up through mounting hole. gasket valve body Ensure valve with mounting washer red striped hose (hot) flange nut is on the left and blue (cold) is on the right.
PAGE 3
Step 5 Install stopper and set eye position Stopper can be removable or non-removable stopper determined by position flange of eye hole when non inserting pivot rod. removable removable ■■ Insert stopper through flange opening and rotate to position eye hole. Thoroughly flush the supply lines to prevent foreign matter, i.e. copper chips, sand, etc. from damaging the sealing surface inside control valves. remove ■■ Remove aerator from aerator end of faucet water outlet by rotating counter clockwise.
PAGE 4
Dimensions Allura Widespread Lavatory Faucet, SLW-4712 6-5/16" (160 mm) 4-1/2" (114 mm) 8" (203 mm) 2-5/16" dia (59 mm) 4" (102 mm) 3-1/8" (79 mm) 2-1/4" dia (58 mm) 3-1/4" (83 mm) 1-5/8" (42 mm) Deck thickness 1-3/8" (35 mm) max. 1" dia. (25 mm) Hole size 1-1/16" (27 mm) min 1-7/16" (37 mm) max Flexible hose Note: Dimensions subject to change without notice.